SICK DT 35 Laser Setup Instructions
- At power up Status Lights Q 1 Q2 & Run are lit Press and hold the Select button for 5 seconds
- Q 1 near will light
- Press Select Button until Q 2 near is lit
- Ensure presshead or ram is in the full retracted or home position
- Press Set Button – Status Lights Q 1 & 02 will both flash twice and come on steady
- Move presshead or ram to the full forward or extended position
- Press Select Button until 02 far is lit
- Press Set Button
- Status Lights Q 1 & 02 will both flash twice then come on steady
- Press Select Button until Speed is lit
- Press Set Button until Speed Light flashes 4 times
- No further action is required at this time. Note after 5 minutes the flashing Speed Light will turn off and Exit from the Teach mode.
SPECIAL NOTES:
- Settings in teach mode are stored immediately after pushing the SET button
- If teaching is successful Status Lights Q 1 & 02 will flash twice together
- If teaching is NOT successful Status Lights 0 1 & 02 will flash altematingly
- If no button is pressed for 5 minutes, the teach mode is left automatically.

- STATUS LIGHTS
- SELECTION LIGHTS
- SELECT BUTTON
- SET BUTTON
SICK DT 50 Adjustment Instructions
- Fully retract head by having motor on and manually overiding the directional valve
- Press set
- Scroll or arrow down to 4ma
- Press set and hold until light blinks twice
- Scroll or arrow down to 20ma
- Fully extend head using manual operation
- Press set and hold until light blinks twice
- Press escape
- Press set twice
- Scroll down to average
- Press set
- Scroll down to slow
- Press set
- Press escape twice
- Setting complete
AB 45LMS Setup Instructions
- The 45lms laser sensor is set up using the rotary switch and the set button, and it displays feedback via the yellow and green led indicators on the top of the sensor.
- Upon completion of any set-point teach, both led’s flash simultaneously, followed by alternating flashing of the led’s.
- A successful teach is indicated by a slower alternating flashing (2.5 hz ).
- An unsuccessful teach is indicated by a faster alternating flashing ( 8 hz ).
- Place the target at the minimun teach point ( ram fully retracted )
- Move the rotary switch to position q2-a
- Press and hold the set button until the green and yellow led’s flash simultaneously, release set button. The successful teach indication slower alternating flashing will come on and when the lights stop flashing.
- Move the rotary switch to position q2-b
- Place the target at the maximun teach point ( ram fully extended )
- Press and hold the set button until the green and yellow led’s flash simultaneously, release set button. The successful teach indication slower alternating flashing will come on and when the lights stop flashing
- If the teach is successful, move the rotary switch to the run position.